Chapter 8: Using the Command Line Interface644If you entered the command without "/y", a message appears, promptingyou to confirm the operation. Then: Type y to confirm the operation, OR Type n to abort the operationExample - Turning On a Specific ActuatorThe following command turns on the actuator whose ID number is 8.# control actuator 8 onUnblocking a UserIf any user is blocked from accessing the PX3TS, you can unblock themat the local console.To unblock a user:1. Log in to the CLI interface using any terminal program via a localconnection. SeeWith HyperTerminal (on page 462).2. When the Username prompt appears, type unblock and pressEnter.3. When the "Username to unblock" prompt appears, type the name ofthe blocked user and press Enter.4. A message appears, indicating that the specified user was unblockedsuccessfully.Resetting the PX3TSYou can reset the PX3TS device to factory defaults or simply restart itusing the CLI commands. In addition, you can reset active energyreadings via CLI.All of these commands begin withreset.
