Chapter 8: Using the Command Line Interface508Setting the Outlet Power-On Sequence DelayThis section applies to outlet-switching capable models only.This command sets the delays (in seconds) for outlets when turning onall outlets in sequence.config:#pdu outletSequenceDelay :;:;:;...Separate outlet numbers and their delay settings with a colon. Outletsfollowed by delays are separated with a semicolon.Variables:, , and the like are individual outletnumbers or a range of outlets using a dash. For example,3-8represents outlets 3 to 8., , and the like are the delay time inseconds.Note: Power-on sequencing is disabled in the latching mode. See PX3TSLatching Relay Behavior(on page 182).Setting the PDU-Defined Default Outlet StateThis section applies to outlet-switching capable models only.This command determines the initial power condition of all outlets afterpowering up the PDU.config:#pdu outletStateOnDeviceStartup Variables:off,on orlastKnownState.OptionDescriptionoffSwitches OFF all outlets when the PX3TS devicepowers up.onSwitches ON all outlets when the PX3TS devicepowers up.
