Chapter 8: Using the Command Line Interface5013. The config:# prompt appears, indicating that you have enteredconfiguration mode.4. Now you can type any configuration command and press Enter tochange the settings.Important: To apply new configuration settings, you must issue the"apply" command before closing the terminal emulation program.Closing the program does not save any configuration changes. SeeQuitting Configuration Mode (on page 501).Quitting Configuration ModeBoth of "apply" and "cancel" commands let you quit the configurationmode. The difference is that "apply" saves all changes you made in theconfiguration mode while "cancel" aborts all changes.To quit the configuration mode, use either command:config:# apply-- OR --config:# cancelThe # or > prompt appears after pressing Enter, indicating that you haveentered the administrator or user mode. SeeDifferent CLI Modes andPrompts (on page 465).PX3TS Control and ConfigurationTo configure the PX3TS device or network settings through the CLI, it ishighly recommended to log in as the administrator so that you have fullpermissions.To configure any settings, enter the configuration mode. Configurationcommands are case sensitive so ensure you capitalize them correctly.Controlling the Transfer SwitchA transfer switch command begins withts. You can use these commandsto control the power transfer behavior or manage power transfersettings.
