Chapter 6: Using the Web Interface271Field/setting DescriptionStatic: Manually configure the IPv4 settings. DHCP settings: Optionally specify the preferred hostname, whichmust meet the following requirements: Consists of alphanumeric characters and/or hyphens Cannot begin or end with a hyphen Cannot contain more than 63 characters Cannot contain punctuation marks, spaces, and other symbols Static settings: Assign a static IPv4 address, which follows thissyntax "IP address/prefix length".Example:192.168.84.99/24IPv6 settings:Field/setting DescriptionEnable IPv6 Enable or disable the IPv6 protocol.IP AutoConfigurationSelect the method to configure IPv6 settings.Automatic: Auto-configure IPv6 settings viaDHCPv6.Static: Manually configure the IPv6 settings. Automatic settings: Optionally specify the preferred hostname,which must meet the above requirements. Static settings: Assign a static IPv6 address, which follows thissyntax "IP address/prefix length".Example:fd07:2fa:6cff:1111::0/128Common Network SettingsCommon Network Settings are OPTIONAL, not required. Therefore, leavethem unchanged if there are no specific local networking requirements.Field DescriptionCascading Mode Leave it to the default "None" unless you areestablishing a cascading chain.For more information, refer to:Cascading Multiple PX3TS Devices forSharing Ethernet Connectivity (on page 28)Setting the Cascading Mode (on page 282)
