Chapter 6: Using the Web Interface350Event/context Default message when the event =TRUEDefault message when the event= FALSELHX/SHX > External WaterCooling FailureAn external water cooling failureoccurred on LHX at [PORTTYPE] port'[PORTID]'.LHX/SHX > Water Leak Water leakage was detected on LHX at[PORTTYPE] port '[PORTID]'.The asterisk symbol (*) represents anything you select for the 'trigger'events.Available ActionsThe PX3TS comes with three built-in actions, which cannot be deleted.You can create additional actions for responding to different events.Built-in actions:System Event Log Action:This action records the selected event in the internal log when theevent occurs.System SNMP Notification Action:This action sends SNMP notifications to one or multiple IP addressesafter the selected event occurs.Note: No IP addresses are specified for this notification action bydefault so you must enter IP addresses before applying this action toany event rule. See Editing or Deleting a Rule/Action(on page 379).Any changes made to the 'SNMP Notifications' section on the SNMPpage will update the settings of the System SNMP Notification Action,and vice versa. See Configuring SNMP Settings(on page 293).System Tamper Alarm:This action causes the PX3TS to show the alarm for the DX tampersensor, if any, on the Dashboard page until a person acknowledges it.By default, this action has been assigned to the built-in tamperdetection event rules. For information on acknowledging an alarm,seeDashboard - Alarms (on page 159).Actions you can create:1. Choose Device Settings > Event Rules > .
