Appendix J: Integration797Associating Outlets with Target DevicesThe Port page opens when you click on a port on the Port Configurationpage.If an outlet is connected to the same server that the port is connected to,a power association can be made with the target device.A server can have up to four power plugs and you can associate adifferent rack PDU (power strip) with each. From this page, you candefine those associations so that you can power on, power off, and powercycle the server from the Port Access page.To use this feature, you will need: Raritan remote rack PDU(s) Power CIMs (D2CIM-PWR)Make a Power AssociationTo make power associations (associate rack PDU outlets to KVMtarget servers):Note: When a rack PDU is associated to a target server (port), the outletname is replaced by the target server name (even if you assignedanother name to the outlet).1. On the Port Configuration page, select the target server you areassociating the PDU with.2. Choose the rack PDU from the Power Strip Name drop-down list.3. For that rack PDU, choose the outlet from the Outlet Namedrop-down list.4. Repeat steps 1 and 2 for all desired power associations.5. Click OK. A confirmation message is displayed.Turning Outlets On/Off and Cycling PowerTo turn an outlet on:1. Click the Power menu to access the Powerstrip page.2. From the Powerstrip drop-down, select the PX rack PDU (powerstrip) you want to turn on.3. Click Refresh to view the power controls.4. Click On next to the outlet you want to power on.5. Click OK to close the Power On confirmation dialog. The outlet willbe turned on and its state will be displayed as 'on'.
