Chapter 6: Using the Web Interface238When the PX3TS detects the connection of any listed device, it replaces'Feature Port' in the menu with that device's name and shows thatdevice's data/settings instead. SeeAsset Strip (on page 239),ExternalBeeper (on page 248),Schroff LHX/SHX (on page 249) andPower CIM(on page 254).When no devices are detected, the PX3TS displays the name 'FeaturePort" and the Feature Port page shows the message "No device iscurrently connected."Open the Feature Port page by clicking it in theMenu (on page 146).From this page, you can enable or disable this port's detection capability,or force it to show a specific device's data/settings even though no deviceis detected.Note: You must enable the LHX/SHX support for the PX3TS to detect thepresence of a supported Schroff® LHX/SHX heat exchanger. SeeMiscellaneous(on page 402).To configure the feature port:1. Click on the top-right corner. The Feature Port Setup dialogappears.2. Click the Detection Mode field, and select one mode.Mode DescriptionAuto Enable the port to automatically detect thedevice connection.Disabled Disable the port's detection capability.
