Appendix J: Integration800Power ControlThe KSX II operation to turn on/off or power cycle a PX is the same as theKX III operation. SeeTurning Outlets On/Off and Cycling Power (onpage 796).Dominion SX and SX IIBy connecting to a Dominion SX or SX II device, you can associate one ormore outlets on a PX3TS device to specific SX or SX II ports.Dominion SX IIThe way to use Dominion SX II to configure and control a Raritan PDU issimilar to using Dominion KX III, but the connection method is differentfrom KX III.Note: If using a CSCSPCS-1 cable for the connection, it must be "Rev.0C".If using a CSCSPCS-10 cable, it must be "Rev.0D".Note that the appliances used in the diagram may not match yourspecific models. However, the connections and ports used are the sameacross models.To connect the SX II to the Feature port on the PX:1. Connect the gray end of the CSCSPCS crossover Cat5 cable into theFeature port on the PX.2. Connect the yellow end of the CSCSPCS crossover Cat5 cable into aport on the SX II.3. Power on the PX (if it is not already).
