Command Manual (For Soliton) – Smart Link-Monitor LinkH3C S3100 Series Ethernet SwitchesChapter 1 Smart Link ConfigurationCommands1-61.1.6 port smart-link groupSyntaxport smart-link group group-id { master | slave }undo port smart-link group group-idViewEthernet port viewParametergroup-id: Smart link group ID, in the range of 1 to 24.master: Configures the port as the master port of the Smart Link group.slave: Configures the port as the slave port of the Smart Link group.DescriptionUse the port smart-link group command to configure the current port as a member ofthe Smart Link group.Use the undo port smart-link group command to remove the current port from thespecified Smart Link group.Either a single port or a link aggregation group configured manually or statically canserve as a member for a Smart Link group. However, a link aggregation groupconfigured dynamically cannot serve as a member for a Smart Link group. Thiscommand is not applicable to member ports in a link aggregation group.Note:Because Smart Link and STP cannot be enabled on an Ethernet port at the same time,you must make sure that STP is disabled on the port before assigning the port to asmart link group.Example# Configure Ethernet1/0/3 as the master port of Smart Link group 1. system-viewSystem View: return to User View with Ctrl+Z.[Sysname] interface Ethernet 1/0/3[Sysname-Ethernet1/0/3] port smart-link group 1 master
