Command Manual (For Soliton) – MSTPH3C S3100 Series Ethernet Switches Chapter 1 MSTP Configuration Commands1-45System View: return to User View with Ctrl+Z.[Sysname] stp pathcost-standard dot1t1.1.39 stp point-to-pointSyntaxstp point-to-point { force-true | force-false | auto }undo stp point-to-pointViewEthernet port viewParametersforce-true: Specifies that the link connected to the current Ethernet port is apoint-to-point link.force-false: Specifies that the link connected to the current Ethernet port is not apoint-to-point link.auto: Specifies to automatically determine whether or not the link connected to thecurrent Ethernet port is a point-to-point link.DescriptionUse the stp point-to-point command to specify whether the link connected to thecurrent Ethernet port is a point-to-point link.Use the undo stp point-to-point command to restore the link connected to the currentEthernet port to its default link type, which is automatically determined by MSTP.By default, whether the link type of a port is point-to-point is automatically determinedby the switch.The rapid transition feature is not applicable to ports connected to non-point-to-pointlinks.Note that:z If the current Ethernet port operates in full duplex mode, the links connected to theport is a point-to-point link. In this case, the default setting (where MSTPdetermines the link type automatically) is recommended.z If the current Ethernet port belongs to an aggregation group and you configure thelink connected to the port as a point-to-point link, the configuration will besynchronized to the rest ports in the aggregation group.z If a port is configured to connect to a point-to-point link (or non-point-to-point link),the port adopts the same configuration in all spanning tree instances.z If a port connects to a non-point-to-point link, but the port is configured to connectto a point-to-point link by mistake, loops may temporarily occur.
