Command Manual (For Soliton) – Information CenterH3C S3100 Series Ethernet SwitchesChapter 1 Information Center ConfigurationCommands1-11This command works only when the information center is enabled.Note:Be sure to set the correct IP address in the info-center loghost command. A loopbackIP address will cause an error message, prompting that the address is invalid.Related command: info-center enable, display info-center.Example# Configure the system to output system information to the Unix log host whose IPaddress is 202.38.160.1. system-viewSystem View: return to User View with Ctrl+Z.[Sysname] info-center loghost 202.38.160.11.1.11 info-center loghost sourceSyntaxinfo-center loghost source interface-type interface-numberundo info-center loghost sourceViewSystem viewParameterinterface-type: Specifies an interface type.interface-number: Specifies an interface number.DescriptionUse the info-center loghost source command to configure the source interfacethrough which information is sent to the log host.Use the undo info-center loghost source command to cancel the source interfaceconfiguration.Related command: info-center enable, display info-center.Example# Configure VLAN-interface 1 as the source interface through which information is sentto the log host.
