Command Manual (For Soliton) – QoS-QoS ProfileH3C S3100 Series Ethernet Switches Chapter 1 QoS Commands1-14Parametergroup-id: Port group ID, in the range 1 to 100. If this argument is not specified, the QoSinformation of all the port groups is displayed.all: Displays all the QoS-related configurations of a port group.traffic-limit: Displays the traffic policing configuration of a port group.traffic-priority: Displays the priority marking configuration of a port group.traffic-redirect: Displays the traffic redirecting configuration of a port group.traffic-statistics: Displays the traffic accounting configuration of a port group.DescriptionUse the display qos-port-group command to display specific QoS-relatedconfiguration of a port group.Example# Display all the QoS-related configurations of port group 1. display qos-port-group 1 allPort-group 1 traffic-limitInbound:Matches: Acl 3001 rule 0 runningTarget rate: 128 KbpsExceed action: dropmeter-statistic not runningRefer to Table 1-1 for the description on the output fields.1.1.15 display qos-vlanSyntaxdisplay qos-vlan [ vlan-id ] { all | mirrored-to | traffic-limit | traffic-priority |traffic-redirect | traffic-statistic }ViewAny viewParametervlan-id: VLAN ID, in the range 1 to 4094. If this argument is not specified, the QoSconfiguration performed for all the VLANs is displayed.all: Displays all the QoS-related configurations performed for packets of a VLAN.traffic-limit: Displays the traffic policing configuration performed for packets of aVLAN.
