Command Manual (For Soliton) – MSTPH3C S3100 Series Ethernet Switches Chapter 1 MSTP Configuration Commands1-24Caution:With the loop guard function enabled, the root guard function and the edge portconfiguration are mutually exclusive.Examples# Configure Ethernet 1/0/1 as a non-edge port. system-viewSystem View: return to User View with Ctrl+Z.[Sysname] interface Ethernet 1/0/1[Sysname-Ethernet1/0/1] stp edged-port disable1.1.21 stp interfaceSyntaxstp interface interface-list { enable | disable }ViewSystem viewParametersinterface-list: Ethernet port list. You can specify multiple Ethernet ports by providing thisargument in the form of interface-list = { interface-type interface-number [ tointerface-type interface-number ] } &<1-10>, where &<1-10> means that you canprovide up to 10 port indexes/port index ranges for this argument.enable: Enables MSTP on the specified ports.disable: Disables MSTP on the specified ports.DescriptionUse the stp interface command to enable or disable MSTP on specified ports insystem view.By default, MSTP is enabled on the ports of a switch if MSTP is globally enabled on theswitch, and MSTP is disabled on the ports if MSTP is globally disabled.An MSTP-disabled port does not participate in any spanning tree calculation and isalways in the forwarding state.
