Command Manual (For Soliton) – GVRPH3C S3100 Series Ethernet Switches Chapter 1 GVRP Configuration Commands1-9# Enable GVRP on Ethernet 1/0/1.[Sysname] interface Ethernet 1/0/1[Sysname-Ethernet1/0/1] gvrpGVRP is enabled on port Ethernet1/0/5.1.2.4 gvrp registrationSyntaxgvrp registration { fixed | forbidden | normal }undo gvrp registrationViewEthernet port viewParametersfixed: Specifies the fixed GVRP registration mode. A port operating in this mode cannotregister or deregister VLAN information dynamically. It only propagates static VLANinformation. Besides, the port permits only static VLANs, that is, it propagates onlystatic VLAN information to the other GARP members.forbidden: Specifies the forbidden GVRP registration mode. A port operating in thismode cannot register or deregister VLAN information dynamically. It permits only VLAN1, that is, it propagates only the information about VLAN 1 to the other GARP members.normal: Specifies the normal mode. A port operating in this mode can dynamicallyregister or deregister VLAN information and can propagate both dynamic and staticVLAN information.DescriptionUse the gvrp registration command to configure the GVRP registration mode on aport.Use the undo gvrp registration command to restore the default GVRP registrationmode on a port.By default, the GVRP registration mode is normal.Note that these commands only apply to trunk ports.Related commands: display gvrp statisticsExamples# Configure Ethernet1/0/1 to operate in fixed GVRP registration mode. system-viewSystem View: return to User View with Ctrl+Z.[Sysname] interface Ethernet1/0/1
