Command Manual (For Soliton) – MSTPH3C S3100 Series Ethernet Switches Chapter 1 MSTP Configuration Commands1-341.1.29 stp interface point-to-pointSyntaxstp interface interface-list point-to-point { force-true | force-false | auto }undo stp interface interface-list point-to-pointViewSystem viewParametersinterface-list: Ethernet port list. You can specify multiple Ethernet ports by providing thisargument in the form of interface-list = { interface-type interface-number [ tointerface-type interface-number ] } &<1-10>, where &<1-10> means that you canprovide up to 10 port indexes/port index ranges for this argument.force-true: Specifies that the links connected to the specified Ethernet ports arepoint-to-point links.force-false: Specifies that the links connected to the specified Ethernet ports are notpoint-to-point links.auto: Specifies to automatically determine whether or not the links connected to thespecified Ethernet ports are point-to-point links.DescriptionUse the stp interface point-to-point command to specify whether the links connectedto the specified Ethernet ports are point-to-point links in system view.Use the undo stp interface point-to-point command to restore the links connected tothe specified ports to their default link types, which are automatically determined byMSTP.If no keyword is specified in the stp interface point-to-point command, the autokeyword is used by default, and so MSTP automatically determines the types of thelinks connected to the specified ports.The rapid transition feature is not applicable to ports connected to non-point-to-pointlinks.Note that:z If the current Ethernet port operates in full duplex mode, the link connected to theport is a point-to-point link. In this case, the default setting (where MSTPdetermines the link type automatically) is recommended.z If the current Ethernet port belongs to an aggregation group and you configure thelink connected to the port as a point-to-point link, the configuration will besynchronized to the rest ports in the aggregation group.
