Command Manual (For Soliton) – IPv6 ManagementH3C S3100 Series Ethernet Switches Chapter 1 IPv6 Configuration Commands1-9Field DescriptionStateState of a neighbor, which can be:z INCMP: Address resolution is in progress, so the linklayer address of the neighbor is unknown yet.z REACH: The neighbor is reachable.z STALE: The reachability to the neighbor is unknown. Thedevice does not verify the reachability to the neighborunless it sends a packet to the neighbor.z DELAY: The reachability to the neighbor is unknown. Thedevice will send a neighbor request message after adelay time.z PROBE: The reachability to the neighbor is unknown.The device sent a neighbor request message to verify thereachability.T Type of neighbor information, including S (staticconfiguration) and D (dynamic acquisition).Agez For a static entry, “-“ is displayed.z For a dynamic entry, the time (in seconds) since it isreachable last time is displayed, and if it is neverreachable, “#” is displayed (for a dynamic neighbor only).1.1.6 display ipv6 neighbors countSyntaxdisplay ipv6 neighbors { all | dynamic | static | interface interface-typeinterface-number | vlan vlan-id } countViewAny viewParametersall: Displays the total number of all neighbor entries, including neighbor entriesacquired dynamically and configured statically.dynamic: Displays the total number of all neighbor entries acquired dynamically.static: Displays the total number of all neighbor entries configured statically.interface interface-type interface-number: Displays the total number of neighborentries of a specified interface.vlan vlan-id: Displays the total number of neighbor entries of a specified VLAN, in therange of 1 to 4,094.count: Number of neighbor entries.
