Command Manual (For Soliton) – GVRPH3C S3100 Series Ethernet Switches Chapter 1 GVRP Configuration Commands1-3z Leave timerz LeaveAll timerz Hold timerRelated commands: garp timer, garp timer leaveall.Examples# Display the settings of the GARP timers on port Ethernet1/0/1. display garp timer interface Ethernet 1/0/1GARP timers on port Ethernet1/0/1Garp Join Time : 20 centisecondsGarp Leave Time : 60 centisecondsGarp LeaveAll Time : 1000 centisecondsGarp Hold Time : 10 centiseconds1.1.3 garp timerSyntaxgarp timer { hold | join | leave } timer-valueundo garp timer { hold | join | leave }ViewEthernet port viewParametershold: Sets the GARP Hold timer.join: Sets the GARP Join timer.leave: Sets the GARP Leave timer.timer-value: Timeout time (in centiseconds) of the GARP timer (Hold, Join or Leave) tobe set.DescriptionUse the garp timer command to set a GARP timer (that is, the Hold timer, the Join timer,or the Leaver timer) for an Ethernet port.Use the undo garp timer command to restore the default setting of a GARP timer.By default, the Hold, Join, and Leave timers are set to 10, 20, and 60 centiseconds.Note that:z The setting of each timer must be a multiple of 5 (in centiseconds).
