Command Manual ( For Soliton ) – Port Security-Port BindingH3C S3100 Series Ethernet Switches Chapter 1 Port Security Commands1-8Caution:Enabling port security resets the following configurations on the ports to the defaults(as shown in parentheses below):z 802.1x (disabled), port access control method (macbased), and port access controlmode (auto)z MAC authentication (disabled)In addition, you cannot perform the above-mentioned configurations manually becausethese configurations change with the port security mode automatically.Related commands: display port-security.Examples# Enable port security. system-viewSystem View: return to User View with Ctrl+Z.[Sysname] port-security enableNotice: The port-control of 802.1x will be restricted to auto whenport-security is enabled.Please wait... Done.1.1.5 port-security intrusion-modeSyntaxport-security intrusion-mode { blockmac | disableport | disableport-temporarily }undo port-security intrusion-modeViewEthernet port viewParametersblockmac: Adds the source MAC addresses of illegal packets to the blocked MACaddress list. As a result, the packets sourced from the blocked MAC addresses will befiltered out. A blocked MAC address will be unblocked three minutes (not userconfigurable) after the block action.disableport: Disables a port permanently once an illegal frame or event is detected onit.
