Command Manual (For Soliton) – Stack-ClusterH3C S3100 Series Ethernet SwitchesChapter 2 HGMP V2 ConfigurationCommands2-62.1.5 reset ndp statisticsSyntaxreset ndp statistics [ interface interface-list ]ViewUser viewParametersinterface-list: Ethernet port list, in the format of { interface-type interface-number [ tointerface-type interface-number ] } &<1-10>, where to is used to specify a port range,and &<1-10> means that you can provide up to ten port indexes/port index ranges forthis argument. The interface-number argument is in the format of unit ID/slotnumber/port number.DescriptionUse the reset ndp statistics command to clear the NDP statistics on specific ports.When executing the command, if you specify the interface keyword, the command willclear NDP statistics on the specified ports; if you do not specify the interface keyword,the command will clear NDP statistics on all ports.You can use the display ndp command to view the NDP statistics before and after theexecution of the reset ndp statistics command to verify the execution result.Examples# Display the NDP statistics on port Ethernet 1/0/6. display ndp interface ethernet 1/0/6Interface: Ethernet1/0/6Status: Enabled, Pkts Snd: 1, Pkts Rvd: 2, Pkts Err: 0# Clear the NDP statistics on port Ethernet 1/0/6. reset ndp statistics interface ethernet 1/0/6# Re-display the NDP statistics on port Ethernet 1/0/6. display ndp interface ethernet 1/0/6Interface: Ethernet1/0/6Status: Enabled, Pkts Snd: 0, Pkts Rvd: 0, Pkts Err: 02.2 NTDP Configuration Commands2.2.1 display ntdpSyntaxdisplay ntdp
