Command Manual (For Soliton) – AAAH3C S3100 Series Ethernet Switches Chapter 1 AAA Configuration Commands1-78and 49 respectively.Note that:z You are not allowed to set the same IP address for both primary and secondaryauthentication servers. If you do this, your setting will fail.z If you re-execute the command, the new setting overwrites the old one.z You can remove an authentication server setting only when there is no active TCPconnection that is sending authentication messages to the server.Related commands: display hwtacacs.Examples# Set the IP address and UDP port number of the secondary authentication server forHWTACACS scheme hwt1 to 10.163.155.13 and 49 respectively. system-viewSystem View: return to User View with Ctrl+Z.[Sysname] hwtacacs scheme hwt1[Sysname-hwtacacs-hwt1] secondary authentication 10.163.155.13 491.3.16 secondary authorizationSyntaxsecondary authorization ip-address [ port ]undo secondary authorizationViewHWTACACS scheme viewParametersip-address: IP address of the secondary authorization server, a valid unicast address indotted decimal notation.port: Port number of the secondary authorization server, ranging from 1 to 65535.DescriptionUse the secondary authorization command to set the IP address and port number ofthe secondary HWTACACS authorization server to be used by the current scheme.Use the .undo secondary authorization command to restore the default IP addressand port number of the secondary HWTACACS authorization server, which are 0.0.0.0and 49 respectively.Note that:z You are not allowed to set the same IP address for both primary and secondaryauthorization servers.
