Command Manual (For Soliton) – MirroringH3C S3100 Series Ethernet Switches Chapter 1 Mirroring Commands1-5 system-viewSystem View: return to User View with Ctrl+Z.[Sysname] mirroring-group 1 local[Sysname] mirroring-group 1 mirroring-port Ethernet 1/0/1 inbound1.1.4 mirroring-group monitor-portSyntaxmirroring-group group-id monitor-port monitor-portundo mirroring-group group-id monitor-port monitor-portViewSystem view, Ethernet port viewParametersgroup-id: Number of a port mirroring group, the value of which can only be 1.monitor-port monitor-port: Specifies the destination port for port mirroring.monitor-port is available in system view only, and there is no such argument in Ethernetport view.DescriptionUse the mirroring-group monitor-port command to configure the destination port fora local mirroring group or a remote destination mirroring group.Use the undo mirroring-group monitor-port to remove the destination port of a localmirroring group or a remote destination mirroring group.Note that:z You cannot configure a member port of an aggregation group, or a port enabledwith LACP or STP as the destination port.z Before configuring a source mirroring port, make sure that the correspondingmirroring group has already been created.z It is recommended that you use a destination port for port mirroring purpose only.Do not use a destination port to transmit other service packets.Related commands: display mirroring-group.Examples# Configure Ethernet 1/0/4 as the destination port of local mirroring group 1. system-viewSystem View: return to User View with Ctrl+Z.[Sysname] mirroring-group 1 local[Sysname] mirroring-group 1 monitor-port Ethernet 1/0/4
