Command Manual (For Soliton) – Information CenterH3C S3100 Series Ethernet SwitchesChapter 1 Information Center ConfigurationCommands1-16Examples# Set the output channel for the log information of VLAN module to snmpagent and tooutput information with severity being emergencies. Log information of other modulescannot be output to this channel. system-view[Sysname] info-center source default channel snmpagent log state off[Sysname] info-center source vlan channel snmpagent log level emergenciesstate on# Set the output channel for the log information of VLAN module to snmpagent and tooutput information with severity being emergencies. Log information of other modulesand all the other system information cannot be output to this channel. system-view[Sysname] info-center source default channel snmpagent debug state off logstate off trap state off[Sysname] info-center source vlan channel snmpagent log level emergenciesstate on1.1.15 info-center synchronousSyntaxinfo-center synchronousundo info-center synchronousViewSystem viewParameterNoneDescriptionUse the info-center synchronous command to enable synchronous informationoutput, so that if system information (such as log information) is output when the user isinputting information, the command prompt and the input information are echoed afterthe output (note that, the command prompt is echoed in command edit state but is notechoed in interactive state).Use the undo info-center synchronous command to disable synchronousinformation output.By default, the synchronous information output function is disabled.
