Appendix A MCU Electrical SpecificationsMC9S12ZVMB Family Reference Manual Rev. 1.3NXP Semiconductors 683PTU This module is enabled, bit TG0EN is set. PTEFRE is also set to generate automaticreload eventsGDU LDO enabled. Charge pump enabled. Current sense enabled.No output activity (too load dependent)COP & RTI EnabledBATS EnabledLINPHY Connected to SCI and continuously transmit data (0x55) at speed of 19200 baudTable A-16. Run and Wait Current CharacteristicsConditions see Table A-14 and Table A-15, VSUP=18 VNum Rating Symbol Min Typ Max Unit1 Run Current, -40C < TJ < 150C, f bus = 32MHz ISUPR — 35.5 45.0 mA2 Wait Current, -40C < T J < 150C, f bus = 32MHz I SUPW — 28.1 36.5 mA3 Run Current, TJ =175×C, f bus = 25MHz ISUPR — 29.0 36.0 mA4 Wait Current, TJ = 175C, fbus = 25MHz I SUPW — 23.0 28.6 mATable A-17. Stop Current CharacteristicsConditions are: V SUP=12 VNum Rating(1)1. If MCU is in STOP long enough then TA = TJ . Die self heating due to stop current is negligibleSymbol Min Typ Max UnitStop Current all modules off1 TA = TJ= -40C I SUPS — 20.3 37.3 A2 TA = TJ = 25C I SUPS — 24.5 37.6 A3 TA = TJ = 105C I SUPS — 80.6 160.0 A4 TA = TJ= 150C I SUPS — 195.3 835.5 AStop Current API enabled & LINPHY in standby5 TA = TJ = 25C I SUPS — 27.0 40.0 ATable A-18. Pseudo Stop Current CharacteristicsConditions are: V SUP=12V, API, COP & RTI enabledNum Rating Symbol Min Typ Max Unit1 T J = 25C I SUPPS — 270.0 399.6 ATable A-15. Peripheral Configurations for Run & Wait Current MeasurementPeripheral Configuration
