Appendix K Ordering InformationMC9S12ZVMB Family Reference Manual Rev. 1.3724 NXP SemiconductorsAppendix KOrdering InformationCustomers can choose either the mask-specific partnumber or the generic, mask-independent partnumber.Ordering a mask-specific partnumber enables the customer to specify which particular maskset theyreceive whereas ordering the generic partnumber means that the currently preferred maskset (which maychange over time) is shipped. In either case, the marking on the device always shows the generic, mask-independent partnumber and the mask set number. To order specific partnumbers, please contact your localsales office. The below figure illustrates the structure of a typical mask-specific ordering number.NOTESNot every combination is offered. Device overview section lists availablederivatives.The mask identifier suffix and the Tape & Reel suffix are always bothomitted from the partnumber which is actually marked on the device.S 9 12ZV MBA 6 F0 M LH RPackage Option:Temperature Option:Device Title (MB or MBA)Core FamilyV = -40°C to 105°CLH = 64LQFPStatus / Partnumber type:S or SC = Maskset specific partnumberMC = Generic / mask-independent partnumberP or PC = prototype status (pre qualification)Main Memory Type:9 = FlashMaskset identifier Suffix:First digit usually references wafer fabSecond digit usually differentiates mask rev(This suffix is omitted in generic partnumbers)Tape & Reel:R = Tape & ReelNo R = No Tape & ReelM = -40°C to 125°CW = -40°C to 150°C (48LQFP only)Memory SizeLF = 48LQFP4 or 48 = 48K Flash6 or 64 = 64K Flash12Z = S12Z 16-Bit MCU CoreV = MagniV FamilyMB = H-Bridge MOS FET predriverMBA = H-Bridge MOS FET predriver with PWM
