Virtual Leased Line Services142FD 100/320Gbps NT and FX NT IHub Services Guide3HH-11985-AAAA-TQZZA Issue: 134.6.6 Show Commands4.6.6.1 egress-labelTable 84 egress-label commandTable 85 describes the command output fields.Table 85 Show Service Egress Label Output FieldsItem DescriptionSyntax egress-label start-label [end-label]Context show>serviceDescription This command displays services using the range of egress labels. If only the mandatorystart-label parameter is specified, only services using the specified label are displayed.If both start-label and end-label parameters are specified, the services using the range of labelsX where start-label <= X <= end-label are displayed.Use the show router ldp bindings command to display dynamic labels.Parameters start-label — The starting egress label value for which to display services using the label range.If only start-label is specified, services only using start-label are displayed.Values: 0, 2049 — 131071end-label — The ending egress label value for which to display services using the label range.Default: the start-label valueValues: 2049 — 131071Label DescriptionSvc Id The ID that identifies a service.Sdp Id The ID that identifies an SDP.Type Indicates whether the SDP binding is a spoke or a mesh.I. Lbl The VC label used by the far-end device to send packets to this device in this service bythe SDP.E. Lbl The VC label used by this device to send packets to the far-end device in this service bythe SDP.Number of bindingsfoundThe total number of SDP bindings that exist within the specified egress label range.
