Services Overview82FD 100/320Gbps NT and FX NT IHub Services Guide3HH-11985-AAAA-TQZZA Issue: 13Table 9 adv-mtu-override command3.17.3.3 far-endTable 10 far-end commandItem DescriptionSyntax [no] adv-mtu-overrideContext configure>service>sdp sdp-idDescription This command overrides the advertised VC-type MTU. When enabled, the ISAM signals a VCMTU equal to the service MTU (includes the Layer 2 header). Under normal operations it willadvertise the service MTU minus the Layer 2 header. In the receive direction, it will accepteither one.The no form of the command disables the VC-type MTU override.Default no adv-mtu-overrideItem DescriptionSyntax far-end ip-addressno far-endContext configure>service>sdp sdp-idDescription This command configures the system IP address of the far-end destination ISAM router for theService Distribution Point (SDP) that is the termination point for a service.The far-end IP address must be explicitly configured. The destination IP address must be aISAM system IP address.The far-end ip-address is used to check LSP names when added to the SDP. If the “to IPaddress” defined within the LSP configuration does not exactly match the SDP far-endip-address, the LSP will not be added to the SDP and an error will be generated.An SDP cannot be administratively enabled until a far-end ip-address is defined. The SDP isoperational when it is administratively enabled (no shutdown) and the far-end ip-address iscontained in the IGP routing table as a host route. OSPF ABRs should not summarize hostroutes between areas. This can cause SDPs to become operationally down. Static host routes(direct and indirect) can be defined in the local ISAM to alleviate this issue.The no form of this command removes the currently configured destination IP address for theSDP. The ip-address parameter is not specified and will generate an error if used in the nofar-end command. The SDP must be administratively disabled using the configure servicesdp shutdown command before the no far-end command can be executed. Removing thefar-end IP address will cause all lsp-name associations with the SDP to be removed.Default noneParameters ip-address — The system address of the far-end ISAM for the SDP in dotted decimal notation.