FD 100/320Gbps NT and FX NT IHub Services Guide Services OverviewIssue: 13 3HH-11985-AAAA-TQZZA 973.17.5.7 pathTable 39 path command3.17.5.8 control-mepTable 40 control-mep command3.17.6 Show CommandsItem DescriptionSyntax path {a|b} port-id raps-tag qtag|qinqtagContext configure>eth-ringDescription This command configures one of the two paths supported under the Ethernet ring.The no form of this command removes the path from under the Ethernet ring.Note: The associated SAP need to be un-configured before the path can be deleted.Parameters port-id - Specifies the physical port /lag for the path.raps-tag ) Specifies the VLAN-ID to be used for Ethernet CFM and G.8031 control planeexchanges.The Q-in-Q RAPS-Tag is allowed on port with Qtag Encapsulation in case of iHUB.The range of Q-in-Q Inner-Tag is [0…4093], a value of 0 Inner-Tag in turn acts as an Qtag. i.e,RAPS and CCM Packets will be sent with Single Outer Tag.Item DescriptionSyntax path {a|b} port-id raps-tag qtagContext configure>eth-ring>path>eth-cfm>mepDescription This command enables the usage of the CC state by the Ethernet ring manager forconsideration in the protection algorithm. The use of the control-mep command isrecommended if fast failure detection is required, especially when Link Layer OAM does notprovide the required detection time.The no form of this command disables the use of the CC state by the Ethernet ring manager
