FD 100/320Gbps NT and FX NT IHub Services Guide Internet Enhanced ServiceIssue: 13 3HH-11985-AAAA-TQZZA 3736.10.4.2 addressTable 330 address commandDescription This command creates a logical IP routing interface for an Internet Enhanced Service (IES).Once created, attributes like an IP address and service access point (SAP) can be associatedwith the IP interface.The interface command, under the context of services, is used to create and maintain IProuting interfaces within IES service IDs. The interface command can be executed in thecontext of an IES service ID. The IP interface created is associated with the service corenetwork routing instance and default routing table. The typical use for IP interfaces created inthis manner is for subscriber internet access. An IP address cannot be assigned to an IESinterface. Multiple SAPs can be assigned to a single group interface.Interface names are case sensitive and must be unique within the group of defined IPinterfaces defined for configure router interface and configure service ies interface (thatis, the network core router instance). Interface names must not be in the dotted decimalnotation of an IP address. For example, the name “1.1.1.1” is not allowed, but “int-1.1.1.1” isallowed. Show commands for router interfaces use either interface names or the IP addresses.Use unique IP address values and IP address names to maintain clarity. It could be unclear tothe user if the same IP address and IP address name values are used. Although notrecommended, duplicate interface names can exist in different router instances.When a new name is entered, a new logical router interface is created. When an existinginterface name is entered, the user enters the router interface context for editing andconfiguration.By default, there are no default IP interface names defined within the system. All IES IPinterfaces must be explicitly defined. Interfaces are created in an enabled state.The no form of this command removes IP the interface and all the associated configuration.The interface must be administratively shutdown before issuing the no interface command.For IES services, the IP interface must be shutdown before the SAP on that interface may beremoved. IES services do not have the shutdown command in the SAP CLI context. IESservice SAPs rely on the interface status to enable and disable them.Parameters ip-int-name — Specifies the name of the IP interface. Interface names must be unique withinthe group of defined IP interfaces for configure router interface and configure service iesinterface commands. An interface name cannot be in the form of an IP address. Interfacenames can be from 1 to 32 alphanumeric characters. If the string contains special characters(#, $, spaces, etc.), the entire string must be enclosed within double quotes.If ip-int-name already exists within the service ID, the context will be changed to maintain thatIP interface. If ip-int-name already exists within another service ID or is an IP interface definedwithin the configure router commands, an error will occur and context will not be changed tothat IP interface. If ip-int-name does not exist, the interface is created and context is changedto that interface for further command processing.Item Description(2 of 2)Item DescriptionSyntax address ip-address/mask-lengthaddress ip-address maskaddress ip-addressno addressContext configure>service>ies>interface(1 of 2)
