Internet Enhanced Service386FD 100/320Gbps NT and FX NT IHub Services Guide3HH-11985-AAAA-TQZZA Issue: 136.10.7 IPv6 Commands6.10.7.1 ipv6Table 352 ipv6 command6.10.7.2 address (ipv6)Table 353 address commandItem DescriptionSyntax [no] ipv6Context configure>service>ies>interfaceDescription This command configures an IPv6 interface.Note — When IPv6 routing is configured on the IHub and aniBridge is configured on the LT board, it is not possible to obtaina DHCPv6 lease when IPv6 multicast control is disabled on theLT board. This is due to the fact that the NT board requiresadding the information in the Neighbor Cache bysending a downstream multicast Neighbor Solicitationmessage. If IPv6 multicast control is disabled on the LT board,such messages are discarded and the DHCPv6 connectioncannot be established. To allow IPv6 routing to work correctly,IPv6 multicast control needs to be allowed on the LT board.See the CLI Command Guide for FD 100/320Gbps NT and FXNT for more informationItem DescriptionSyntax address ipv6-address/prefix-length [eui-64]no address ipv6-address/prefix-lengthContext configure>service>ies>interface>ipv6Description This command assigns an IPv6 address to the IES interface.Up to 254 global IPv6 addresses can be configured.Note: The ISAM supports configuration of IPv6 interfaces with a prefix length up to /126. TheISAM does not support /127 addresses.(1 of 2)
