FD 100/320Gbps NT and FX NT IHub Services Guide Internet Enhanced ServiceIssue: 13 3HH-11985-AAAA-TQZZA 3976.10.8.2 filterTable 372 filter command6.10.8.3 egressTable 373 egress commandItem DescriptionSyntax filter { ip ip-filter-id| ipv6 ipv6-filter-id}no filter [ip ip-filter-id] [ipv6 ipv6-filter-id]Context configure>service>ies>interface>sap>egressconfigure>service>ies>interface>sap>ingressDescription This command associates a filter policy with an ingress or egress Service Access Point (SAP).Filter policies control the forwarding and dropping of packets based on the matching criteria.The filter command is used to associate a filter policy with a specified ip-filter-id with an ingressor egress SAP. The filter policy must already be defined before the filter command isexecuted. If the filter policy does not exist, the operation will fail and an error messagereturned.In general, filters applied to SAPs (ingress or egress) apply to all packets on the SAP. Oneexception is non-IP packets are not applied to the match criteria, so the default action in thefilter policy applies to these packets.The no form of this command removes any configured filter ID association with the SAP. Thefilter ID itself is not removed from the system unless the scope of the created filter is set to local.To avoid deletion of the filter ID and only break the association with the service object, usescope command within the filter definition to change the scope to local or global. The defaultscope of a filter is local.Special cases IES — Only IP filters are supported on an IES IP interface, and the filters only apply to routedtraffic.Parameters ip — Keyword indicating the filter policy is an IP filter.ip-filter-id — Specifies the ID for the IP filter policy. Allowed values are an integer in the rangeof 1 and 65535 that corresponds to a previously created IP filter policy in theconfigure>filter>ip-filter context.ipv6 — Keyword indicating the filter policy is an IPv6 filter.ipv6-filter-id — Specifies the ID for the IPv6 filter policy. Allowed values are an integer in therange of 1 and 65535 that corresponds to a previously created IP filter policy in theconfigure>filter>ipv6-filter context.Item DescriptionSyntax egressContext configure>service>ies>interface>sapDescription This command enables the context to configure egress SAP filter policies.If no egress filter is defined, no filtering is performed
