FD 100/320Gbps NT and FX NT IHub Services Guide Virtual Private LAN ServiceIssue: 13 3HH-11985-AAAA-TQZZA 2995.16.4.5 eth-cfmTable 212 eth-cfm commandDescription This command creates a local static MAC entry in the v-VPLS forwarding database (FDB)associated with the SAP.In a v-VPLS service, MAC addresses are associated with an SAP or with a Service DistributionPoint (SDP). MACs associated with an SAP are classified as local MACs, and MACsassociated with an SDP are remote MACs.Local static MAC entries create a permanent MAC address to SAP association in theforwarding database for the v-VPLS instance so that MAC address will not be learned on theedge device.Note that static MAC definitions on one edge device are not propagated to other edge devicesparticipating in the VPLS instance, that is, each edge device has an independent forwardingdatabase for the v-VPLS.Only one static MAC entry (local or remote) can be defined per MAC address per v-VPLSinstance.By default, no static MAC address entries are defined for the SAP.The no form of this command deletes the static MAC entry with the specified MAC addressassociated with the SAP from the v-VPLS forwarding database.Parameters ieee-mac-address — Specifies the 48-bit MAC address for the static ARP in the formaa:bb:cc:dd:ee:ff or aa-bb-cc-dd-ee-ff where aa, bb, cc, dd, ee and ff are hexadecimalnumbers.Allowed values are any non-broadcast, non-multicast MAC and non-IEEE reserved MACaddresses.Item Description(2 of 2)Item DescriptionSyntax eth-cfmContext configure>service>vpls>sapconfigure>service>vpls>mesh-sdpconfigure>service>vpls>spoke-sdpconfigure>eth-ring>pathDescription This command enables the context to configure 802.1ag CFM parameters
