FD 100/320Gbps NT and FX NT IHub Services Guide Virtual Private LAN ServiceIssue: 13 3HH-11985-AAAA-TQZZA 3135.16.6.6 query-response-intervalTable 240 query-response-interval command5.16.6.7 query-src-ipTable 241 query-src-ip commandItem DescriptionSyntax query-response-interval secondsno query-response-intervalContext configure>service>vpls>sap>igmp-snoopingDescription This command configures the IGMP query response interval. If the send-queries command isenabled, this parameter specifies the maximum response time advertised in IGMPv2/v3queries.The configured query-response-interval must be smaller than the configured query-interval.If send-queries is not enabled on this SAP, the configured query-response-interval value isignored.Default 10Parameters seconds — Specifies the length of time to wait to receive a response to the host-querymessage from the host.Values: 1 — 1023Item DescriptionSyntax query-src-ip ip-addressno query-src-ipContext configure>service>vpls>igmp-snoopingDescription This command configures the specific IP source address used in IGMP queries.The no form of the command removes the specific IP source address used in IGMP queries.Parameters ip-address — The IP source address used in queries.
