Virtual Private Routed Network Service488FD 100/320Gbps NT and FX NT IHub Services Guide3HH-11985-AAAA-TQZZA Issue: 137.10.6.14 param-problemTable 478 param-problem commandDescription This command configures the rate for ICMP packet-too-big messages issued on the routerinterface.By default, generation of ICMP packet-too-big messages is enabled at a maximum rate of 100per 10 second time interval.The no form of this command disables the limiting the rate of packet-too-big on the routerinterface.Default packet-too-big 100 10Parameters number — The maximum number of ICMP time-exceeded messages to send. This parametermust be specified with the seconds parameter.Values: 10 — 1000seconds — The time frame in seconds used to limit the number of ICMP time-exceededmessages that can be issued.Values: 1 — 60Item Description(2 of 2)Item DescriptionSyntax param-problem [number seconds]no param-problemContext configure>service>vprn>interface>ipv6>icmp6Description This command configures the rate for ICMP param-problem messages issued on the routerinterface.By default, generation of ICMP param-problem messages is enabled at a maximum rate of 100per 10 second time interval.The no form of this command disables the limiting the rate of param-problem on the routerinterface.Default param-problem 100 10Parameters number — The maximum number of ICMP param-problem messages to send. This parametermust be specified with the seconds parameter.Values: 10 — 1000seconds — The time frame in seconds used to limit the number of ICMP param-problemmessages that can be issued.Values: 1 — 60
