FD 100/320Gbps NT and FX NT IHub Services Guide Internet Enhanced ServiceIssue: 13 3HH-11985-AAAA-TQZZA 3716.10.3.4 rate-limitTable 327 rate-limit command6.10.3.5 rate-limitTable 328 rate-limit commandItem DescriptionSyntax rate-limit cir cir-rate pir pir-rate [cbs cbs-size] [pbs pbs-size]no rate-limitContext configure>service>ies>egressDescription This command defines the aggregate egress rate limit per IES service.It applies to traffic associated to the IES service which is egressing on regular ports (networkports)The committed information rate and the peak information rate are enteredOptionally, the committed burst size and the peak burst size may be entered. If these valuesare not specified, they assume the default value of 256 Mbytes.The no form of this command removes rate limiting from a IES.Parameters cir cir-rate — The committed information rate expressed in kbps.Values: up to 100 Gbpspir pir-rate — The peak information rate expressed in kbps.Values: up to 100 Gbpscbs cbs-size — The committed burst size expressed in kBytes.Default: 256 MbytesValues: up to 256 Mbytespbs pbs-size — The peak burst size expressed in kBytes.Default: 256 MbytesValues: up to 256 MbytesItem DescriptionSyntax rate-limit cir cir-rate pir pir-rate [cbs cbs-size] [pbs pbs-size]no rate-limitContext configure>service>ies>ingressDescription This command defines the aggregate ingress rate limit per VPLS service.It applies to traffic associated to the VPLS service which is ingressing on regular ports (networkports)The committed information rate and the peak information rate are enteredOptionally, the committed burst size and the peak burst size may be entered. If these valuesare not specified, they assume the default value of 256 Mbytes.The no form of this command removes rate limiting from a VPLS.(1 of 2)
