Virtual Private Routed Network Service518FD 100/320Gbps NT and FX NT IHub Services Guide3HH-11985-AAAA-TQZZA Issue: 137.10.9.34 passiveTable 531 passive command7.10.9.35 peer-asTable 532 peer-as commandItem DescriptionSyntax [no] passiveContext configure>service>vprn>bgp>groupconfigure>service>vprn>bgp>group>neighborDescription This command enables passive mode for the BGP group or neighbor.When in passive mode, BGP will not attempt to actively connect to the configured BGP peersbut responds only when it receives a connect open request from the peer.The no form of the command used at the group level disables passive mode where BGPactively attempts to connect to its peers.The no form of the command used at the neighbor level reverts to the value defined at thegroup level.Default no passive — BGP will actively try to connect to all the configured peers.Item DescriptionSyntax peer-as as-numberno peer-asContext configure>service>vprn>bgp>groupconfigure>service>vprn>bgp>group>neighborDescription This command configures the autonomous system number for the remote peer. The peer ASnumber must be configured for each configured peer.For EBGP peers, the peer AS number configured must be different from the autonomoussystem number configured for this router under the global level since the peer will be in adifferent autonomous system than this routerFor IBGP peers, the peer AS number must be the same as the autonomous system number ofthis router configured under the global level.This is a required command for each configured peer. This may be configured under the grouplevel for all neighbors in a particular group.Default no peer-asParameters as-number — The autonomous system number, expressed as a decimal integer.Values: 1 — 65535
