Virtual Private Routed Network Service472FD 100/320Gbps NT and FX NT IHub Services Guide3HH-11985-AAAA-TQZZA Issue: 13Table 446 bfd command7.10.3.5 delayed-enableTable 447 delayed-enable commandItem DescriptionSyntax bfd transmit-interval [receive receive-interval] [multiplier multiplierno bfdContext configure>service>vprn>interfaceDescription This command specifies the bidirectional forwarding detection (BFD) parameters for theassociated IP interface. If no parameters are defined the default values are used.The multiplier specifies the number of consecutive BFD messages that must be missed fromthe peer before the BFD session state is changed to down and the upper level protocols(OSPF, IS-IS, BGP or PIM) is notified of the fault.The no form of the command removes BFD from the router interface.Default no bfdParameters transmit-interval - Sets the transmit interval, in milliseconds, for the BFD session.Values 100 — 100000Default: 100receive receive-interval - Sets the receive interval, in milliseconds, for the BFD session.Values 100 — 100000Default: 100multiplier multiplier - Set the multiplier for the BFD session.Values 3 — 20Default: 3Item DescriptionSyntax delayed-enable delay-in-secondsno delayed-enableContext configure>service>vprn>interfaceDescription This command configures the delay making interface operational by the specified number ofsecondsThe no form of the command reverts to the default value.Default 300 secondsParameters seconds — Specifies the delay time interval in seconds.Values 1 — 300
