Virtual Private LAN Service316FD 100/320Gbps NT and FX NT IHub Services Guide3HH-11985-AAAA-TQZZA Issue: 135.16.6.12 groupTable 246 group command5.16.6.13 sourceTable 247 source commandItem DescriptionSyntax group grp-ip-address[no] groupContext configure>service>vpls>igmp-snooping>staticconfigure>service>vpls>sap>igmp-snooping>staticconfigure>service>mesh-sdp>igmp-snooping>staticconfigure>service>spoke-sdp>igmp-snooping>staticDescription This command adds a static multicast group either as a (*,G) or one or more (S,G) records.Use IGMP static group memberships to test multicast forwarding without a receiver host. WhenIGMP static groups are enabled, data is forwarded to an interface without receivingmembership reports from host members.In case of VPLS context, data will be forwarded to all interfaces of the given service.Default NoneParameters grp-ip-address — Specifies an IGMP multicast group address that receives data on aninterface. The IP address must be unique for each static group. Specify the address in dotteddecimal notation.Item DescriptionSyntax source ip-address[no] sourceContext configure>service>vpls>igmp-snooping>static>groupconfigure>service>vpls>sap>igmp-snooping>static>groupconfigure>service>mesh-sdp>igmp-snooping>static>groupconfigure>service>spoke-sdp>igmp-snooping>static>groupDescription This command specifies a IPv4 unicast address that sends data on an interface. This enablesa multicast receiver host to signal a router the group is to receive multicast traffic from, andfrom the source(s) that the traffic is expected.The source command is mutually exclusive with the specification of individual sources for thesame group.The source command in combination with the group is used to create a specific (S,G) staticgroup entry.In case of VPLS context, the data will be forwarded to all interfaces of the given service.Use the no form of the command to remove the source from the configuration.Default None(1 of 2)
