Garmin G1000 NXi Pilot's Manual

Also see for G1000 NXi: Cockpit reference guide Supplemental Maintenance Manual Cockpit reference guide Reference guide Pilot's guide

Contents

Garmin G1000 NXi Pilot’s Guide for the Cessna Nav III190-02177-00 Rev. ASYSTEMOVERVIEW FLIGHTINSTRUMENTS EIS AUDIO PANEL& CNS FLIGHTMANAGEMENT HAZARDAVOIDANCE AFCS ADDITIONALFEATURES APPENDICES INDEX93AUDIO PANEL AND CNS1 NAV VOL/ID Knob – Controls NAV audio volume level. Press to turn the Morse code identifier audio onand off. Volume level is shown in the NAV frequency field as a percentage.2 NAV Frequency Transfer Key – Transfers the standby and active NAV frequencies.3 NAV Knob – Tunes the standby frequencies for the NAV receiver (large knob for MHz; small knob for kHz).Press to move the frequency selected for tuning (light blue numbers) and the Frequency Transfer Arrowbetween NAV1 and NAV2.4 NAV Frequency Box – Displays NAV standby and active frequency fields, volume, and station ID. Thefrequency of the NAV radio selected for navigation is displayed in green.5 COM Frequency Box – Displays COM standby and active frequency fields and volume. The selected anddecoded COM transceiver frequency is displayed in green.6 COM Knob – Tunes the standby frequencies for the COM transceiver (large knob for MHz; small knob forkHz). Press to move the frequency selected for tuning (light blue numbers) and the Frequency TransferArrow between COM1 and COM2.7 COM Frequency Transfer Key – Transfers the standby and active COM frequencies. Press and hold this keyfor two seconds to tune the emergency frequency (121.500 MHz) automatically into the active frequencyfield.8 COM VOL/SQ Knob – Controls COM audio volume level. Press to turn the COM automatic squelch onand off. Volume level is shown in the COM frequency field as a percentage.9 DME Tuning Window – Displays DME frequency pairing mode. Display by selecting the DME Softkey.10 ENT Key – Validates or confirms DME pairing mode and Auto-tune selection.11 FMS Knob – Flight Management System Knob, used to enter transponder codes, select DME modes, andAuto-tune entries when DME Tuning Window or NRST Window is present. Press the FMS Knob to turnthe selection cursor on and off. The large knob moves the cursor in the window. The small knob selectsindividual characters for the highlighted cursor location.12 Transponder Data Box – Indicates the selected transponder code, operating mode, reply, and ident statusfor the applicable transponder.13 DME Softkey – Displays the DME Tuning Window.