190-02177-00 Rev. A Garmin G1000 NXi Pilot’s Guide for the Cessna Nav III61FLIGHT INSTRUMENTSSYSTEMOVERVIEW FLIGHTINSTRUMENTS EIS AUDIO PANEL&CNS FLIGHTMANAGEMENT HAZARDAVOIDANCE AFCS ADDITIONALFEATURES APPENDICES INDEXFlight Phase Annunciation* Automatic CDI Full-scale DeflectionDeparture DPRT 0.3 nmTerminal TERM 1.0 nmEnroute ENR 2.0 nmOceanic OCN 2.0 nmApproach(Non-precision) LNAV1.0 nm decreasing to 350 feet depending onvariables (Figure 2-24)Approach(Non-precision withAdvisory VerticalGuidance)LNAV + VApproach(Non-precision withAdvisory VerticalGuidance)VISUALApproach(LNAV/VNAV) L/VNAV1.0 nm decreasing to a specified course width, then0.3 nm, depending on variables (Figure 2-25)Approach(LPV) LPVApproach(Non-precision withAdvisory VerticalGuidance)LP+VApproach(LP) LPMissed Approach MAPR 0.3 nm* Flight phase annunciations are normally shown in magenta, but when cautionaryconditions exist the color changes to amber.Table 2-2 Automatic GPS CDI ScalingOBS MODENOTE: VNV is inhibited while automatic waypoint sequencing has been suspended.Enabling Omni-bearing Selector (OBS) Mode suspends the automatic sequencing of waypoints in a GPSflight plan (GPS must be the selected navigation source), but retains the current Active-to waypoint as thenavigation reference even after passing the waypoint. OBS is annunciated to the lower right of the aircraftsymbol when OBS Mode is selected.While OBS Mode is enabled, a course line is drawn through the Active-to waypoint on the moving map. Ifdesired, the course to/from the waypoint can now be adjusted. When OBS Mode is disabled, the GPS flightplan returns to normal operation, with automatic sequencing of waypoints, following the course set in OBSMode. The flight plan on the moving map retains the modified course line.
