Garmin G1000 NXi Pilot’s Guide for the Cessna Nav III 190-02177-00 Rev. ASYSTEMOVERVIEWFLIGHTINSTRUMENTSEISAUDIO PANEL& CNSFLIGHTMANAGEMENTHAZARDAVOIDANCEAFCSADDITIONALFEATURESAPPENDICESINDEX288HAZARD AVOIDANCE1) Select the Navigation Map Page.2) Press the MENU Key.3) Turn the FMS Knob to highlight ‘Clear Stormscope® Lightning’, then press the ENT Key.Displaying Stormscope information on MFD navigation maps:1) Press the Map Opt Softkey.2) Press the STRMSCP Softkey.Displaying Stormscope information on PFD maps:1) On the PFD, press the Map/HSI Softkey.2) Press the Lightning Softkey.3) Press the STRMSCP Softkey.SETTING UP STORMSCOPE ON THE NAVIGATION MAPSetting up Stormscope options on the Navigation Map:1) On the Navigation Map Page, press the MENU Key.2) With ‘Map Settings’ selected, press the ENT Key.3) Turn the small FMS Knob to display the group selection window. Turn the small FMS Knob to select ‘Weather’,and press the ENT Key.4) Turn the large FMS Knob to highlight and move between the product selections.5) When an item is highlighted, turn the small FMS Knob to select the option.6) Press the ENT Key.7) Press the FMS Knob to return to the Navigation Map Page.The following options are available:• Stormscope On/Off field – Enables/disables the display of Stormscope lightning symbols.• Stormscope maximum display range – Selects the maximum map range to display Stormscope symbols.Stormscope data is removed when a map range greater than the STRMSCP SMBL value is selected.• Stormscope Mode – Selects the Cell or Strike mode of lightning activity. Cell mode identifies clusters orcells of electrical activity. Strike mode indicates the approximate location of lightning strikes.CELL AND STRIKE MODE ON THE NAVIGATION MAPOn the Navigation Map, cell mode identifies cells of lightning activity. Stormscope identifies clusters ofelectrical activity that indicate cells. Strike mode indicates the approximate location of lightning strikes.Selecting the ‘cell’ or ‘strike’ mode on the Navigation Map:1) Press the MENU Key.2) With ‘Map Settings’ selected, press the ENT Key.
