190-02177-00 Rev. A Garmin G1000 NXi Pilot’s Guide for the Cessna Nav IIIiWARNINGS, CAUTIONS, AND NOTESWARNING: Do not use terrain avoidance displays as the sole source of information for maintaining separationfrom terrain and obstacles. Garmin obtains terrain and obstacle data from third party sources and cannotindependently verify the accuracy of the information.WARNING: Always refer to current aeronautical charts and NOTAMs for verification of displayed aeronauticalinformation. Displayed aeronautical data may not incorporate the latest NOTAM information.WARNING: Do not use geometric altitude for compliance with air traffic control altitude requirements. Theprimary barometric altimeter must be used for compliance with all air traffic control altitude regulations,requirements, instructions, and clearances.WARNING: Do not use basemap information (land and water data) as the sole means of navigation. Basemapdata is intended only to supplement other approved navigation data sources and should be considered onlyan aid to enhance situational awareness.WARNING: Do not rely solely upon the display of traffic information to accurately depict all of the trafficwithin range of the aircraft. Due to lack of equipment, poor signal reception, and/or inaccurate informationfrom aircraft or ground stations, traffic may be present that is not represented on the display.WARNING: Do not use data link weather information for maneuvering in, near, or around areas of hazardousweather. Information contained within data link weather products may not accurately depict currentweather conditions.WARNING: Do not use the indicated data link weather product age to determine the age of the weatherinformation shown by the data link weather product. Due to time delays inherent in gathering and processingweather data for data link transmission, the weather information shown by the data link weather productmay be older than the indicated weather product age.WARNING: The displayed minimum safe altitude (MSAs) are only advisory in nature and should not be reliedupon as the sole source of obstacle and terrain avoidance information. Always refer to current aeronauticalcharts for appropriate minimum clearance altitudes.WARNING: Always obtain qualified instruction prior to operational use of this equipment.WARNING:Do not use a QFE altimeter setting with this system. System functions will not operate properlywith a QFE altimeter setting. Use only a QNH altimeter setting for height above mean sea level, or thestandard pressure setting, as applicable.