Operation Manual –IP Address-IP PerformanceH3C S3100 Series Ethernet Switches Chapter 1 IP Addressing Configuration1-4Note:This chapter only covers how to assign an IP address manually. For the other twoapproaches to IP address assignment, refer to the part discussing DHCP in thismanual.Table 1-2 Configure an IP address to an interfaceOperation Command RemarksEnter system view system-view ––Enter interface view interface interface-typeinterface-number ––Assign an IP address tothe Interfaceip address ip-address{ mask | mask-length }RequiredNo IP address is assignedby default.Note:z A newly specified IP address overwrites the previous one if there is any.z The IP address of a VLAN interface must not be on the same network segment asthat of a loopback interface on a device.1.3 Displaying IP Addressing ConfigurationAfter the above configuration, you can execute the display command in any view todisplay the operating status and configuration on the interface to verify yourconfiguration.Table 1-3 Display IP addressing configurationOperation Command RemarksDisplay information about aspecified or all Layer 3interfacesdisplay ip interface[ interface-typeinterface-number ]Display brief configurationinformation about a specifiedor all Layer 3 interfacesdisplay ip interface brief[ interface-type[ interface-number ] ]Available in anyview
