Operation Manual – Port Basic ConfigurationH3C S3100 Series Ethernet Switches Chapter 1 Port Basic Configuration1-2Operation Command RemarksSet the speed of theEthernet portspeed { 10 | 100 | 1000 |auto }Optionalz By default, the speedof an Ethernet port isdetermined throughauto-negotiation (theauto keyword).z Use the 1000 keywordfor Gigabit Ethernetports only.Set the mediumdependent interface (MDI)mode of the Ethernet portmdi { across | auto |normal }OptionalBe default, the MDI modeof an Ethernet port isauto.Set the maximum framesize allowed on theEthernet port to 2048bytes (Only S3100-EISeries switches supportthis feature)jumboframe enableOptionalBy default, the maximumframe size allowed on anEthernet port is 2048bytes.1.1.2 Limiting Traffic on individual PortsBy performing the following configurations, you can limit the incoming broadcast/unknown multicast/unknown unicast traffic on individual ports. When a type of incomingtraffic exceeds the threshold you set, the system drops the packets exceeding the trafficlimit to reduce the traffic ratio of this type to the reasonable range, so as to keep normalnetwork service.Table 1-2 Limit traffic on portOperation Command RemarksEnter system view system-view —Limit broadcast trafficreceived on each portbroadcast-suppressionratioOptionalBy default, the switchdoes not suppressbroadcast traffic.Enter Ethernet port view interface interface-typeinterface-number —Limit broadcast trafficreceived on the currentportbroadcast-suppression{ ratio | bps max-bps }OptionalBy default, the switchdoes not suppressbroadcast traffic.