Operation Manual – LoginH3C S3100 Series Ethernet Switches Chapter 2 Logging in through the Console Port2-12III. Configuration procedure# Enter system view. system-view# Enter AUX user interface view.[Sysname] user-interface aux 0# Specify to authenticate users logging in through the Console port using the localpassword.[Sysname-ui-aux0] authentication-mode password# Set the local password to 123456 (in plain text).[Sysname-ui-aux0] set authentication password simple 123456# Specify commands of level 2 are available to users logging into the AUX userinterface.[Sysname-ui-aux0] user privilege level 2# Set the baud rate of the Console port to 19,200 bps.[Sysname-ui-aux0] speed 19200# Set the maximum number of lines the screen can contain to 30.[Sysname-ui-aux0] screen-length 30# Set the maximum number of commands the history command buffer can store to 20.[Sysname-ui-aux0] history-command max-size 20# Set the timeout time of the AUX user interface to 6 minutes.[Sysname-ui-aux0] idle-timeout 6After the above configuration, you need to modify the configuration of the terminalemulation utility running on the PC accordingly in the dialog box shown in Figure 2-4 tolog into the switch successfully.
