Operation Manual – Information CenterH3C S3100 Series Ethernet Switches Chapter 1 Information Center1-81.2 Information Center Configuration1.2.1 Introduction to the Information Center Configuration TasksTable 1-4 Information center configuration tasksTask RemarksConfiguring Synchronous Information Output OptionalConfiguring to Display the Time Stamp with the UTC Time Zone OptionalSetting to Output System Information to the Console OptionalSetting to Output System Information to a Monitor Terminal OptionalSetting to Output System Information to a Log Host OptionalSetting to Output System Information to the Trap Buffer OptionalSetting to Output System Information to the Log Buffer OptionalSetting to Output System Information to the SNMP NMS Optional1.2.2 Configuring Synchronous Information OutputSynchronous information output refers to the feature that if the system information suchas log, trap, or debugging information is output when the user is inputting commands,the command line prompt (in command editing mode a prompt, or a [Y/N] string ininteraction mode) and the input information are echoed after the output.This feature is used in the case that your input is interrupted by a large amount ofsystem output. With this feature enabled, the system echoes your previous input andyou can continue your operations from where you were stopped.Table 1-5 Configure synchronous information outputOperation Command DescriptionEnter system view system-view —Enable synchronousinformation outputinfo-centersynchronousRequiredDisabled by default
