Operation Manual – VLAN-VPNH3C S3100 Series Ethernet Switches Chapter 3 VLAN Mapping Configuration3-3Operation Command DescriptionEnable the VLANmapping function vlan-mapping enableRequiredBy default, the VLANmapping function isdisabled.Note:z A port that is in a link aggregation port group cannot have the VLAN Mappingfeature enabled.z The VLAN mapping function and the protocol-based VLAN function are mutuallyexclusive on the same port.z Enabling the VLAN mapping function based on a global VLAN mapping rule for aport also enables the selective QinQ function on the port.3.2.3 Enabling the VLAN Mapping Function Based on a Port-level VLANMapping RuleTable 3-3 Enable the VLAN mapping function based on a port-level VLAN mappingruleOperation Command DescriptionEnter system view system-view —Enter Ethernet portviewinterface interface-typeinterface-number —Define a VLANmapping rulevlan-mapping vlanold-vlan-id remarknew-vlan-idRequiredThis command also enables theVLAN mapping function for theport.By default, no VLAN mapping ruleis defined, and the VLANmapping function is not enabledon a port.