Operation Manual – QoS-QoS ProfileH3C S3100 Series Ethernet Switches Chapter 1 QoS Configuration1-32Table 1-32 Generate traffic statistics on packets passing a port and matching specificACL rulesOperation Command DescriptionEnter system view system-view —Enter Ethernet port view interface interface-typeinterface-number —Generate the statistics on the packetsmatching specific ACL rulestraffic-statisticinbound acl-rule RequiredClear the statistics on the packetsmatching specific ACL rulesreset traffic-statisticinbound acl-rule OptionalNote:The traffic accounting function configured on a VLAN is only applicable to packetstagged with 802.1Q header.III. Configuration examplez Ethernet 1/0/1 is connected to the 10.1.1.0/24 network segment.z Generate statistics on the packets sourced from the 10.1.1.0/24 network segment.z Clear the statistics.1) Method I system-view[Sysname] acl number 2000[Sysname-acl-basic-2000] rule permit source 10.1.1.1 0.0.0.255[Sysname-acl-basic-2000] quit[Sysname] interface Ethernet1/0/1[Sysname-Ethernet1/0/1] traffic-statistic inbound ip-group 2000[Sysname-Ethernet1/0/1] reset traffic-statistic inbound ip-group 20002) Method II system-view[Sysname] acl number 2000[Sysname-acl-basic-2000] rule permit source 10.1.1.1 0.0.0.255[Sysname-acl-basic-2000] quit[Sysname] traffic-statistic vlan 2 inbound ip-group 2000[Sysname] reset traffic-statistic vlan 2 inbound ip-group 20001.4.10 Enabling the Burst FunctionRefer to section Burst for information about the burst function.
