Operation Manual – System Maintenance and DebuggingH3C S3100 Series Ethernet SwitchesChapter 1 Boot ROM and Host SoftwareLoading1-7Figure 1-5 Sending file pageStep 9: After the sending process completes, the system displays the followinginformation:Loading ...CCCCCCCCCC done!Step 10: Reset HyperTerminal’s baudrate to 9600 bps (refer to Step 4 and 5). Then,press any key as prompted. The system will display the following information when itcompletes the loading.Bootrom updating.....................................done!Note:z If the HyperTerminal’s baudrate is not reset to 9600 bps, the system prompts "Yourbaudrate should be set to 9600 bps again! Press enter key when ready".z You need not reset the HyperTerminal’s baudrate and can skip the last step if youhave chosen 9600 bps. In this case, the system upgrades the Boot ROMautomatically and prompts “Bootrom updating now.....................................done!”.III. Loading host softwareFollow these steps to load the host software:Step 1: Select <1> in BOOT Menu and press . The system displays thefollowing information:1. Set TFTP protocol parameter2. Set FTP protocol parameter
