Operation Manual – QoS-QoS ProfileH3C S3100 Series Ethernet Switches Chapter 1 QoS Configuration1-27I. Configuration prerequisitesz The port on which port rate limiting configuration is to be performed is determined.z The target rate and the direction of rate limiting (inbound or outbound) aredetermined.II. Configuration procedureTable 1-23 Configure port rate limitingOperation Command DescriptionEnter system view system-view —Enter Ethernetport viewinterface interface-typeinterface-number —Configure portrate limitingline-rate { inbound | outbound }target-rateRequiredBy default, port ratelimiting is disabled.III. Configuration examplez Configure port rate limiting for inbound packets on Ethernet 1/0/1.z The rate limit is 1,024 KbpsConfiguration procedure: system-view[Sysname] interface Ethernet 1/0/1[Sysname-Ethernet1/0/1] line-rate inbound 10241.4.7 Configuring Traffic RedirectingNote:Only H3C S3100-EI series switches support this configuration.Refer to section Traffic Redirecting for information about traffic redirecting.I. Configuration prerequisitesz The ACL rules used for traffic classification are defined. Refer to the ACL moduleof this manual for information about defining ACL rules.z The traffic redirecting destination is determined.
