Operation Manual – Stack-ClusterH3C S3100 Series Ethernet Switches Chapter 1 Stack1-4You can configure the stack-port function on the stack ports that are connected withother switches to choose whether to send join-in requests to the switches, so as toprevent the switches that do not belong to the local stack from joining in.II. Stack-Port Function ConfigurationFollow these steps to configure the stack port function:To do… Use the command… RemarksEnter system view system-view —Enter port view interface interface-typeinterface-number —Enable the stack-portfunction on the stack port stack-port enableRequiredEnabled by default.After a switch joins in astack or becomes themaster switch of a stack,the switch willsend/forward stack join-inrequests through thisstack port.1.3 Slave Switch ConfigurationJust make sure the slave switch is connected to the main switch through the stack ports.No configuration is needed.1.4 Displaying and Debugging a StackOperation Command DescriptionDisplay the stackstatus informationon the main switchdisplay stacking[ members ]OptionalThe display command can beexecuted in any view.When executed without the memberskeyword specified, this commanddisplays the main switch and thenumber of switches in the stack.When being executed with themembers keyword specified, thiscommand displays the memberinformation of the stack, includingstack number, device name, MACaddresses and status of the mainswitch/slave switches.